Hazard Warning Switch; Windshield Wiper And Washer Lever - Suzuki IGNIS 2022 Series Manual

BEFORE DRIVING

Hazard warning switch

EXAMPLE
Push in the hazard warning switch to acti-
vate the hazard warning lights. All turn sig-
nal lights and both turn signal indicators
will flash simultaneously. To turn off the
lights, push the switch again.
Use the hazard warning lights to warn
other drivers of possible risk of traffic haz-
ard when you park your vehicle in case of
emergency.
2-133
Windshield wiper and washer
lever
75RM324
To avoid possible injury, do not oper-
ate controls by reaching through the
steering wheel.
65D611
WARNING
Wiper and washer operation
When the ignition switch is in "ON" position
or the ignition mode is ON, you can use
the wiper/washer lever or switch (if
equipped).
When the wipers are under heavy load
such as covered by snow, the breaker will
be activated and the wipers will stop oper-
ating to protect the wiper motor from over-
heating.
If the wiper stops during operation, do the
following methods.
1) Stop the vehicle in a safe place, and
turn the engine off.
2) Move the wiper lever and switch to
"OFF" position.
3) Remove obstacles such as snow on the
wipers.
4) After a while, when the temperature of
the wiper motor becomes low enough,
the breaker will be reset automatically
and you will be able to use the wipers.
If you cannot use the wipers after a while,
there may be another problem. Ask your
SUZUKI dealer to have the wipers
inspected.