Drive Belt Inspection; Engine Oil Change; Engine Oil Filter Change; Drive Belt (For Water Pump And Generator) - Mitsubishi 1989-1993 GALANT Service Manual

GENERAL - Maintenance Service
6. DRIVE BELT (For Water Pump and
Generator) (Inspect for tension)
(2) Measure the deflection with a force of 100 N (22 Ibs.)
applied to belt mid-point between water pump pulley
and generator pulley. If the standard value is not ob-
tained, make adjustment.
(3) Use a tension gauge to check the belt tension. If the
standard value is not obtained, make adjustment.
When tension gauge is used, the tension may be
measured between any two pulleys.
Standard value: 250-500 N (55-110 Ibs.)
7. ENGINE OIL (Change)
Always use lubricants which conform to the requirements
of the API classification "For Service SG" or "For Service
number for the expected temperature range.
Never Lose nondetergent or straight mineral oil.
(1) After warming up the engine, remove the oil filler cap.
(2) Remove the drain plug to drain the engine oil.
(3) Replace the drain plug gasket with a new one and
tighten the drain plug.
(4) Supply new engine oil through the oil filler.
Engiine oil capacity:
Items
Models built up to
Oil pan
April 1992
Models built from May 1992
Oil filter
Oil cooler (clnly models with turbo)
(5) Start and run the engine a few minutes.
(6) Stop the engine and check the engine oil level.
8. ENGINE OIL FILTER (Change)
The quality of replacement filters varies considerably. Only
high quatlity filters should be used to assure most efficient
service.
Genuine oil filters require that the filter is capable of
and are recommended as follows:
Oil Filter Part No.
Mitsubishi Genuine Parts: MD135737, MD136466
TSB Revision
Engine oil capacity
3.5 dm3 (3.7 qts.)
SOHC
DOHC 4.0 dm3 (4.2 qts.)
4.0 dm3 (4.2 qts.)
0.3 dm3 (l/2 qt.)
0.3 dm3 (I/2 qt.)