31-4
WHEEL AND TIRE - Service Adjustment Procedures
W ear indicator
SERVICE ADJUSTMENT PROCEDURES
TIRE INFLATION PRESSURE CHECK
Check the inflation pressure of the tires. If it is not within the
standard value, make the necessary adjustment.
TIRE WEAR CHECK
Measure the tread depth of tires.
Limit: 1.6 mm (.06 in.)
If the remaining tread depth is less than the limit, replace the
tire.
NOTE
When the tread depth of tires is reduced to 1.6 mm LO6 in.) or
less, wear indicators will appear.
WHEEL RUNOUT CHECK
Jack up the vehicle so that the wheels are clear of the floor.
While slowly turning the wheel, measure wheel runout with a
dial indicator.
Limit:
Radial
Lateral
<Steel type>
If wheel runout exceeds the limit, replace the wheel.
TSB Revision
1.2 mm (.047 in.)
in.)
1 .O mm (.039
1.2 mm (.047 in.)
1 .O mm (.039 in.)