Mitsubishi 1989-1993 GALANT Service Manual page 830

PROPELLER SHAFT - Propeller Shaft
Mating
marks
1. INSTALLATION OF SNAP RING
TSB Revision
(2) Press fit the journal bearings to the yoke by using the
general service tool according to the following proce-
fit them by using the general service tool.
(1) Install snap rings of the same thickness onto both sides
of each yoke.
(2) Press the bearing and journal into one side by using a
brass bar with a diameter of 15 mm (59 in.).
(3) Measure the clearance between the snap ring and the
groove wall of the yoke with a filler gauge.
If the clearance exceeds the standard value, the snap
rings should be replaced.
Standard value: 0.02-0.06 mm (.0008-.0024