Mitsubishi 1989-1993 GALANT Service Manual page 119

ENGINE <DOHC>
Plastic hammer
Exhaust side
Intake side
Slits
SERVICE POINTS OF REMOVAL
11. REMOVAL OF EXHAUST CAMSHAFT SPROCKET/
12. INTAKE CAMSHAFT SPROCKET
(1) Using a wrench at the hexagonal part of the camshaft
(to prevent the crankshaft from turning), loosen the
cramshaft sprocket bolt.
(2) Remove the camshaft sprokets.
13. REMOVAL OF CAMSHAFT OIL SEALS
Remove the oil seals using a screwdriver or similar tool.
Caution
Take care not to damage front camshaft bearing cap
and camshaft.
(1) Loosen the bearing cap installation bolts in two or
three steps.
(2) Remove the bearing cap.
NOTE
If the bearing cap is difficult to remove, use a plastic
hammer to gently tap the rear part of the camshaft,
and then remove.
SERVICE POINTS
OF INSTALLATION
19. INSTALLATION OF INTAKE CAMSHAFT/18. EXHAUST
CAMSHAFT
(1) Install the camshafts on the cylinder head.
Caution
Be sure not to mistake the intake side and th!
exhaust side. There are slits for crankshaft posl-
shaft.
end of the intake cam-
rear