Removal Of Power Steering Oil Pump; Removal Of Air Conditioning Compressor; Removal Of Engine Mount Bracket; Removal/Installation Of Engine Assembly - Mitsubishi 1989-1993 GALANT Service Manual

ENGINE <SOHC> - Engine Assembly
SERVICE POINTS OF REMOVAL

24. REMOVAL OF POWER STEERING OIL PUMP

Remove the oil pump (with the hose attached).
NOTE
Suspend the removed oil pump (by using wire or similar
material) at a place where no damage will be caused
during removal/installation of the engine assembly.
25. REMOVAL OF AIR CONDITIONING
Disconnect the connection of the air conditioning compres-
sor, and then remove the compressor (with the hose at-
tached) from the compressor bracket.
NOTE
Suspend the removed air conditioning compressor (by
using wire or similar material) at a place where no damage
will be caused during removal/installation of the engine as-
sembly.

29. REMOVAL OF ENGINE MOUNT BRACKET

then suspend (to the extent that there is no slackness
of the wire) by using a chain block or similar arrange-
ment.
(2) Remove the engine mount bracket.
31. REMOVAL OF ENGINE ASSEMBLY
(1) Check to be sure that all cables, hoses, harness
connectors, etc. are disconnected from the engine.
(2) Lift the chain block slowly to remove the engine
a s s e m b l y u p w a r d f r o m t h e e n g i n e c o m p a r t m e n t .
SERVICE POINTS OF INSTALLATION
31. INSTALLATION OF ENGINE ASSEMBLY
Install the engine assembly. When doing so, check
carefully to be sure that all pipes and hoses are con-
nected, and that none are twisted, damaged, etc.
25. INSTALLATION OF AIR CONDITIONING
Adjust belt tension. (Refer to P.
Ml 1SBBC
COMPRESSOR
2.)
1 1-l