Speedometer Cable Replacement (Automatic Transaxle) - Mitsubishi 1989-1993 GALANT Service Manual

AUTOMATIC TRANSAXLE
1 6 0 0 2 4
TSB Revision
(3) Using the special tool, tap the drive shaft oil seal into the
transaxle.
(4) Apply a coating of the transaxle fluid to the lip of the oil seal.
Transaxle fluid: DIAMOND ATF SP or equivalent
SPEEDOMETER CABLE REPLACEMENT
fasten the new speedometer cable.
2. Install the grommet so that, as shown in the illustration, the
cable attachment part is positioned upward.
Caution
(1) The cable arrangement should be made so that the
radius of cable bends is 150 mm (5.9 in.) or more.
(2) The arrangement of the speedometer cable should
be such that it does not interfere with brake tubes,
etc.
3. At the transaxle end of the speedometer cable, the key
joint should be inserted into the transaxle, and the nut
should be securely tightened.
Caution
If the cable is not correctly and securely connected, it
may cause incorrect indication by the speedometer, or
abnormal noise. Be sure to connect it correctly.
23-93