Mitsubishi 1989-1993 GALANT Service Manual page 912

POWER PLANT MOUNT - Engine Roll Stopper
86.7-92.7 mm
(1.8-2.1 in.)
SERVICE POINTS OF INSTALLATION
6. INSTALLATION OF REAR ROLL STOPPER BRACKET
in.)
<Vehicles with FWD-A/T>
After temporarily tightening the rear roll stopper bracket,
Rear roll
tighten so that, in the unladen vehicle condition, the
dimension of the clearance of the insulator is the specified
dimension.
<Vehicles with AWD-A/T>
Rear roll
After temporarily tightening the rear roll stopper bracket,
tighten so that, in the unladen vehicle condition, the
distance from the center hole of the insulator to the lower
edge of the bracket is the specified distance.
3. INSTALLATION OF FRONT ROLL STOPPER BRACKET
Front roll
stopper bracket
Front roll
stopper
bracket
,
where the round hole is made is facing the front of the
vehicle.
bracket, tighten so that, in the unladen vehicle condi-
tion, the distance from the center hole of the insulator
to the lower edge of the bracket is the specified
distance.