Installation Of Flange (Dohc); Installation Of Crankshaft Sprocket (Dohc); Installation Of Oil Pump Sprocket (Dohc); Installation Of Camshaft Sprockets (Dohc) - Mitsubishi 1989-1993 GALANT Service Manual

installation bolt ~~~
Crankshaft
"B"
sprocket
Crankshaft /
Flange Crankshaft
sprocket
E N G I N E < D O H C > - Timing Belt
(3) To ensure that the tension is correct, depress the belt
(point A) with a finger. If not, adjust.
Standard value: 5-7 mm (.20-.28 in.)
29. INSTALLATION OF FLANGE
Install the flange in correct direction as shown
Caution
Pay special attention to the direction of the flange. If it
is installed in the wrong direction, a broken timing belt
could result.
28. INSTALLATION OF CRANKSHAFT SPROCKET
Install the crankshaft sprocket in the correct direction as
shown.
Caution
Pay special attention to the direction of the flange. If it
is installed in the wrong direction, a broken timing belt
could result.
25. INSTALLATION OF OIL PUMP SPROCKET
(1) Insert a Phillips screwdriver [shank diameter 8 mm (.31
in.) shaft] through the plug hole on the left side of
cylinder block to block the left silent shaft.
(2) Install the oil pump sprocket.
(3) apply engine oil to the nut bearing surface and tighten
the nut to the specified torque.
24. INSTALLATION OF CAMSHAFT SPROCKETS
Using a wrench, hold the camshaft at its hexagon (between
the No.2 and No.3 journals) and tighten the bolt to
specification.
Caution
Locking the camshaft sprocket with a tool damages the
sprocket.
TSB Revision