Hub And Knuckle Disassembly And Reassembly - Mitsubishi 1989-1993 GALANT Service Manual

DISASSEMBLY AND REASSEMBLY
Disassembly steps
2. Oil seal (drive shaft side)
3. Snap ring
4. Oil seal (hub side)
5. Wheel bearing
6. Dust shield
7. Knuckle
8. Front toothed
(Refer to GROUP 35-Wheel Speed
Sensor.)
FRONT AXLE - Hub and Knuckle
9-14
rotor <A.B.S.>
SERVICE POINTS OF DISASSEMBLY
1. REMOVAL OF FRONT HUB
(1) Attach the
(2) Secure the knuckle in a vise.
(3) Tighten the nut of the special tool and remove the front
hub from the knuckle.
Caution
1. Be sure to use the special tools.
2. If the front hub and knuckle are disassembled by
TSB Revision
Nm
8
Reassembly steps
8. Front toothed rotor
(Refer to GROUP 35-Wheel Speed
Sensor.)
7. Knuckle.
6. Dust shield
l
+ 4. Oil seal (hub side)
3. Snap ring
Adiustment of wheel bearing starting
tools to the knuckle and front hub.
special
striking them with a hammer, the bearing will
be damaged.
1