Reducing Pressure Adjustment - Mitsubishi 1989-1993 GALANT Service Manual

AUTOMATIC TRANSAXLE - Service Adjustment Procedures
15. Tighten valve body assembly mounting.
Valve body assembly mounting bolts:
A: 18 mm (.709 in.) long
B: 25 mm (.984 in.) long
C: 40 mm (1.575 in.) long
Caution (AWD)
Fix the solenoid valve and oil temperature sensor harness
securely in the position shown. Since the harness of the
pressure control solenoid valve (PCSV) is separately
provided from the other harness, route the former
harness as illustrated and clamp it. If clamping is
forgotten, it will come into contact with the detent plate
and parking rod.
16. Install the oil filter.
17. Install a new oil pan gasket and oil pan.
18. Pour in the specified amount of Automatic transaxle fluid.
19. Make the oil pressure test. Readjust if necessary.

REDUCING PRESSURE ADJUSTMENT

(If the scan tool is not available)
1. Remove parts up to the oil filter in the same way as for
adjustment of the line pressure. The valve body need not
be removed.
2. Turn the adjustment screw of the lower valve body and
adjust so that the reducing pressure is the standard value.
When the adjustment screw is turned to the right, the
reducing pressure becomes lower; when it is turned to the
left, it becomes higher.
11 Nm (8.0 ftlbs.)