Mitsubishi 1989-1993 GALANT Service Manual page 825

Washer
Inner race
Recessed end
of inner race
Chamfered end
fitting the packing
PROPELLER SHAFT - Propeller Shaft
SERVICE POINTS OF REASSEMBLY
19. INSTALLATION OF WASHER/18. LOBRO JOINT BOOT
OR D.O.J. BOOT/17. BOOT BAND/lG. R U B B E R
ASSEMBLY / 14. SNAP RING
shaft.
(2) Wrap the splined end of center propeller shaft with
adhesive tape.
(3) Install the Lobro joint boot on the center propeller shaft
Tape
and then remove the adhesive tape on the splined end
of the propeller shaft.
with their mating marks aligned.
will be fitted) of the inner race, the recessed end
(where packing will be fitted) of the outer race, and
the chamfered end of the cage are all on the same
side. Also ensure that the relative positions of the
inner and outer races are as shown in the illustra-
tion.
smoothly.
TSB Revision
grooves of the inner and outer races.
Specified grease: Repair kit grease
marks aligned and install two balls, one in a groove
and the other in the groove opposite to that groove.
Both balls should be placed in the grooves where
they were before disassembly.
NOTE
Make sure that the recessed end (where snap ring