Mitsubishi 1989-1993 GALANT Service Manual page 841

FRONT AXLE
SERVICE POINTS OF REASSEMBLY
5. INSTALLATION OF WHEEL BEARING
(1) Fill the wheel bearing with multipurpose grease.
(2) Apply a thin coating of multipurpose grease to the
knuckle and bearing contact surfaces.
(3) With the wheel bearing inner
the bearing by using the special tools.
(4) Install the wheel bearing inner race to the wheel
bearing.
4. INSTALLATION OF OIL SEAL (HUB SIDE)
(1) Drive the oil seal (hub side) into the knuckle by using
the special tools until it is flush with the knuckle end
surface.
(2) Apply multipurpose grease to the lip of the oil seal and
to the surfaces of the oil seal which contact the front
hub.
1. INSTALLATION OF FRONT HUB
(1) Use the special tool to mount the front hub assembly
onto the knuckle.
(2) Tighten the nut of the special tool to 200-260 Nm
(3) Rotate the front hub assembly in order to seat the
bearing.
(4) Leave the special tool in place and take the measure-
ments described below.
ADJUSTMENT OF WHEEL BEARING STARTING
l
TORQUE
(1) Measure the wheel bearing starting torque (hub
starting torque) by using the special tools.
Limit: 1.8 Nm (16 in.lbs.) or less
NOTE
The starting torque must be within the limit and, in
addition, the bearing must not feel rough when
rotated.
TSB Revision
removed, press-in