Drive Shaft (Fwd) - Mitsubishi 1989-1993 GALANT Service Manual

DRIVE SHAFT <FWD>
The T.J.-R.J. type of drive shaft is used for SOHC
engines, and the T.J.-B.J. type is used for DOHC
e n g i n e s .
PARTS DISTINCTION
Boots and boot bands can be distinguished by the
indicated part numbers shown below.
T.J. boot band
Part shapes and
part identification
number location
location
Part identification No.
NOTE
T.J. boot band
Identification
Part shapes and
location
part identification
number location
Part identification No.
FRONT AXLE
(2) Measure to determine whether the end play of the hub
(3) If the starting torque and hub end play are not within the
2. INSTALLATION OF OIL SEAL (DRIVE SHAFT SIDE)
Drive the oil seal (drive shaft side) into the knuckle until it
contacts the snap ring.
Apply multipurpose grease to the lip of the oil seal.
T.J. boot
Identification
location
019
is within the specified limit or not.
Limit: 0.2 mm (.008 in.) or less
limit range while the nut is tightened to 200-260 Nm
probably not been installed correctly. Repeat the
disassembly and assembly procedure.
Boot band (small) R.J. boot
identification
Identification
location
location
I 020
B.J. boot
Identification
location
17-31 #BJ92L
Identification
B.J. boot band
Identification
location