Basic Idle Speed Adjustment - Mitsubishi 1989-1993 GALANT Service Manual

FUEL SYSTEM <SOHC-8 VALVE> -
For a male pin
For a female pin
(Insert at lock tab side.,
(insert at side
opposite from lock tab.)
CHART CLASSIFIED BY PROBLEM SYMPTOMS and
check the MFI component.

BASIC IDLE SPEED ADJUSTMENT

inspection and adjustment.
Engine coolant temperature: 85-95°C (185-205°F)
l
Lights, electric cooling fan and accessories: OFF
l
Transaxle: Neutral (P for vehicles with an automatic
l
(2) Slacken the accelerator cable enough.
(3) Connect the scan tool to the data link connector (white).
(4)
If the scan tool is not used, follow the steps below.
connector shown in the figure at the left.
Take care not to disconnect the connector.
Caution
The paper clip should be inserted between the
terminals as shown in the figure at the left.,
meter to the paper clip.
TSB Revision
Service Adjustment Procedures 13-33
transaxle)