Mitsubishi 1989-1993 GALANT Service Manual page 65

3 5 - 4 5
2 5 - 3 3
23
Removal steps
1. Connection for accelerator cable
(Refer to GROUP 13-Service Adjustment
Procedures.)
2. Connection for heater hose
3. Connection for brake booster vacuum
hose
4. Connection for fuel high pressure hose
5. O-ring
6. Connection for fuel return hose
7. Connection for vacuum hose
8. Connection for oxygen sensor
9. Connection for engine coolant
temperature gauge unit
temperature sensor
11. Connection for ISC
12. Connection for injector
(California vehicles only)
14. Connection for ignition power transistor
16. Connection for TPS
17. Connection for idle speed control motor
position sensor
18. Connection for distributor
ENGINE <SOHC> - Engine Assembly
24
3 5 - 4 5 N m
2 5 - 3 3 ft.lbs.
22-29 ft.lbs. \
3 6 - 4 7 ft.lbs.* -
3 5 - 4 5 N m
2 5 - 3 3 ft.lbs.
2 3 - 2 7
25
22-29 ft.lbs.
19. Connection for crankshaft position sensor
wiring harness
21. Control
22. Connection for generator
23. Connection for oil pressure switch
l + 25. Air conditioning compressor
26. Self-locking nuts
27. Gasket
28. Clamp of pressure hose (Power steering)
and high pressure hose (Air conditioning)
29. Engine mount bracket
30. Self locking nut
tighten temporarily, and then make the final tightenrng wrth
3 6 - 4 7 ft.lbs.
cable