Mitsubishi 1989-1993 GALANT Service Manual page 828

Mounting bolts
D.O.J. boot
Boot band
Rubber mount
Dust seal
PROPELLER SHAFT - Propeller Shaft
king
(8) Realign the bolt holes in the boot and D.O.J. assembly
utilizing the mounting bolts and fit the boot on the joint
assembly.
(9) Secure the boot with the boot band.
Caution
Position the boot band clip on the side opposite to
the bosses which are provided in the boot for
ventilation. Be sure to remove grease, if present,
from around the bosses. Grease obstructs the
ventilation air passage.
12. INSTALLATION OF CENTER BEARING ASSEMBLY
I
and rear grease grooves and
(2) Be sure to fit the bearing into the rubber mount groove
on the center bearing bracket.
NOTE
Face the bearing dust seal to the side of center bearing
bracket mating mark.
shaft and rear propeller shaft.
Apply a thin and even coat of the specified grease to
the rubber packing and fit the packing in the boot
side end of the D.O.J. assembly.
Specified grease: Repair kit grease
Caution
For the D.O.J. assembly, the side that has the
concave part (for the rubber packing) in the
outer race is the D.O.J. boot side.
to
the dust seal lip.