Engine Coolant Change; Disc Brake Pads Inspection; Rear Drum Brake Linings And Rear Wheel Cylinders Inspection - Mitsubishi 1989-1993 GALANT Service Manual

GENERAL - Maintenance Service
Then, with parking brake on, move selector fever
momentarily to each position, ending in "N" Neutral
position.
Recheck fluid level after transaxle is at normal
temperature.
Fluid level should be between upper and lower marks of
"HOT" range, Insert dipstick fully to prevent dirt from
entering transaxle.
11 .ENGINE COOLANT (Change)
Check the cooling system parts, such as radiator, heater,
and oil cooler hoses, thermostat and connections for
leakage and damage.
CHANGE COOLANT
2. Loosen the drain plug to drain the coolant.
3. Drain the coolant from the reserve tank.
4. After draining the coolant, tighten the drain plug
securely.
5. Supply the coolant into the radiator until it is filled up to
its filler neck.
6. Supply the coolant into the reserve tank.
7. After warming the engine until the thermostat opens,
remove the radiator cap and check the coolant level.
8. Supply the coolant into the radiator until it is filled up to
its filler neck, and install the radiator cap securely.
9. Fill the reserve tank with coolant up to the "FULL" line.
1
Check for fluid contamination and wear. Replace complete
set of pads if defective.
Caution
The pads for the right and left wheels should be
All four pads must be replace as a complete set.
Thickness
Limit: 2.0 mm (.08 in.)
WHEEL CYLINDERS (Inspect for wear and
leaks)
1. Remove the brake drum and check the thickness of
brake shoe lining for wear. Check the automatic brake
adjusting system by hand to see if it operates smoothly.
Also see if the gears are in proper mesh with each
other. To assure smooth functioning, apply a very thin
coat of multipurpose grease to the friction surface of
adjuster and link shaft.
TSB Revision
of (A)
lining
Operating