FRONT SUSPENSION - Lower Arm
BALL JOINT DUST COVER REPLACEMENTM~~NEAF
(1) Remove the dust cover.
(2) Apply multipurpose grease to the lip and inside of the dust
cover.
(3) Drive in the dust cover with special tool until it is fully
seated.
SERVICE POINTS OF INSTALLATION
5. INSTALLATION OF STABILIZER LINK MOUNTING
NUTS
Using a wrench or similar tool to secure the ball studs at
both ends of the stabilizer link, tighten the mounting nuts.
1. INSTALLATION OF STABILIZER BAR MOUNTING NUT
Tighten the nut on the stabilizer bar bolt to the specified
distance.
Protruding length of stabilizer bar mounting bolt
Standard value: 16-18 mm (.63-.70 in.)
TSB Revision