Actuator Inspection; Idle Speed Control Motor (Dc Motor) (From 1990 Models) - Mitsubishi 1989-1993 GALANT Service Manual

Idle speed control
motor connector
Idle speed control
motor connector
IDLE SPEED CONTROL MOTOR (DC MOTOR) <From 1990 models>
OPERATION
TROUBLESHOOTING HINTS
Refer to P. ? 3-93.

ACTUATOR INSPECTION

(1) Disconnect the idle speed control motor connector.
(2) Check continuity of the idle speed control motor coil.
Measuring terminals
(3) Connect 6V DC between terminal @I and terminal @ of the
idle speed control motor connector, and check to be sure
that the idle speed control motor operates.
Caution
Apply only a 6V DC or lower voltage. Application of
higher voltage could cause locking of the servo gears.
(4) If not, replace idle speed control motor as an assembly.
Component side
connector
Engine control module connector
TSB Revision
Continuity
5 to 359 resistance at 20°C (68°F)
Engine control module
:
Idle speed
control motor