Rear Axle (Awd) Drive Shaft Removal And Installation - Mitsubishi 1989-1993 GALANT Service Manual

REMOVAL AND INSTALLATION
Removal steps
1. Bolt
l
+ 2. Drive shaft
3. Circlip
l
4 4. Oil seal
REAR AXLE <AWD>
SERVICE POINTS OF REMOVAL
2. REMOVAL OF DRIVE SHAFT
Using a tire lever, etc. remove the drive shaft from the
differential carrier.
INSPECTION
Check the drive shaft boots for damage or deterioration.
l
Check the ball joints (B.J. and D.O.J.) for excessive play or
l
check operation.
SERVICE POINTS OF INSTALLATION
4. INSTALLATlON OF OIL SEAL
If the oil seal is to be replaced because of damage, drive it
in by using the special tool.
2. INSTALLATION OF
Caution
Be cautious to ensure that the differential carrier oil
seal is not damaged by the drive shaft spline.
TSB Revision
Shaft
DRIVE SHAFT
27-21