Mitsubishi 1989-1993 GALANT Service Manual page 823

(commercially avaiiabl
Mating marks
PROPELLER SHAFT - Propeller Shaft
(2) After placing mating marks on the center bearing
assembly (front) bracket and center propeller shaft, and
the center bearing assembly (rear) bracket and rear
propeller shaft, remove the center bearing bracket.
Caution
The mounting rubber cannot be removed from the
center bearing bracket.
(3) Pull out the front and rear center bearings with a
commercially available puller.
15. REMOVAL OF LOBRO JOINT ASSEMBLY <M/T>
assembly.
(2) Remove the Lobro joint assembly as follows:
race with a scriber.
Caution
Note the positions of balls so that they can be
reinstalled in their original positions.
propeller shaft by using a commercially available
puller.
NOTE
When changing the grease on the Lobro joint
assembly, wipe off the grease and clean the outer
and inner races, cage and balls.
I