Mitsubishi 1989-1993 GALANT Service Manual page 930

Bump rubber
Dust iover
010
Pipe mm x 300
in. x 11.8
FRONT SUSPENSION
SERVICE POINTS OF REASSEMBLY
7. INSTALLATION OF DUST COVER/G. BUMP RUBBER
Join the dust cover and bump rubber.
4. INSTALLATION OF SPRING UPPER SEAT ASSEMBLY
(1) Assemble the sprivg upper seat to the piston rod,
fitting the notch in
seat.
(2) Line
seat with the hole in the spring upper seat.
NOTE
The job is easily accomplished with a pipe [alO mm x
300 mm
2. INSTALLATON OF SELF-LOCKING NUT
tools (MB991237 and MB991238),
the self-locking nut.
(2) Correctly align both ends of the coil spring with
grooves in the spring seat, and then loosen the special
tools (MB991237 and MB991238).
(3) Using the special tool, tighten the strut insulator at the
specified torque.
TSB Revision
rod to the shaped hole in spring
the
up the holes in the strut assembly spring lower
in. x 11.8 in.)].
temporarily tighten
the