Fuel Pump And Gauge Assembly Replacement (Dohc) - Mitsubishi 1989-1993 GALANT Service Manual

<DOHC>
FUEL SYSTEM
FUEL PUMP AND GAUGE ASSEMBLY REPLACE-
MENT
(1) Remove the protectors.
(2) Disconnect the fuel pump and gauge assembly harness
connector, and then remove the hole cover.
(3) Bleed the remaining pressure from the fuel pipe line to
prevent fuel discharge. (Refer to P.13-312.)
(4) Disconnect fuel high pressure hose and remove the fuel
tank pressure control valve, then remove the fuel pump
and gauge assembly.
(5) Apply the specified sealant to the rear floor pan.
Specified sealant: 3M ATD Part No.8625 or equivalent
(6) After installing the fuel pump and gauge assembly, start the
engine and check to ensure that there is no fuel leakage.
TSB Revision
13-323