Mitsubishi 1989-1993 GALANT Service Manual page 895

I
REAR AXLE <AWD>
SERVICE POINTS OF REASSEMBLY
2. PRESS FITTING OF OIL SEAL
(1) With the special tool, press fit the oil seal until it is
(2) Apply multipurpose grease to the oil seal lip.
3. INSTALLATION OF DRIVE PINION REAR BEARING
OUTER RACE/A DRIVE PINION FRONT BEARING
OUTER RACE
Press-fit the drive pinion rear
into the gear carrier by using the special tool.
Caution
Be careful not to press in the outer race at an angle.
. ADJUSTMENT OF PINION HEIGHT
Adjust the drive pinion height by the following procedures:
bearing inner races on the gear carrier in the sequence
shown in the illustration.
(2) Tighten the handle of the special tool until the standard
value of drive pinion turning torque is obtained.
(3) Ea;sure the drive pinion turning torque (without the oil
Standard value:
NOTE
(1) Gradually tighten the handle ?f the special tool while
(2) Because the special tool cannot be turqed one tur?, turn
with the end of the gear carrier.
and front bearing outer races
Bearing
Bearing
classification lubrication
checking the drive pinion turning torque.
it several times within the range that It can be turned;
then, after fitting to the bearing, measure the rotation
torque.
27-35
flush
Rotation torque
(starting friction torque)
Nm