Mitsubishi 1989-1993 GALANT Service Manual page 879

REAR AXLE <AWD> - Axle Shaft
Trailing arm
Trailing arm
Outer bearing
Seal lip surfac'
SERVICE POINTS OF INSTALLATION
15. INSTALLATION OF INNER BEARING
With the special tool, press fit the inner bearing onto the
trailing arm.
14. INSTALLATION OF OIL SEAL
With the special tool, press fit the oil seal onto the trailing
arm with the depression in the oil seal facing upward, and
until it contacts the shoulder on the inside of the inner arm.
NOTE
When tapping the oil seal in, use a plastic hammer to lightly
tap the top and circumference of the special tool, press
fitting gradually and evenly.
12. INSTALLATION OF DUST COVER
Orienting the dust cover as shown in the illustration, and
using the special tool, press fit the dust cover until it
contacts the axle shaft shoulder.
NOTE
When tapping the oil seal in, use a plastic hammer to lightly
tap the top and circumference of the special tool, press
fitting gradually and evenly.
11. INSTALLATION OF DUST COVER
With the special tool, install the dust cover so that the
depression is facing upward.
NOTE
When tapping the oil seal in, use a plastic hammer to lightly
tap the top and circumference of the special tool, press
fitting gradually and evenly.
10. INSTALLATION OF OUTER BEARING
cumference of the inner side of the outer bearing seal
lip.
bearing seal lip surface is facing towards the axle shaft
flange.
111026
I