Mitsubishi 1989-1993 GALANT Service Manual page 829

PROPELLER SHAFT - Propeller Shaft
NOTE
Face the side onto which the center bearing bracket
mating mark is placed and the dust seal is installed to
the side of the center propeller shaft and rear propeller
shaft.
11. INSTALLATION OF RUBBER PACKING/lo. COMPAN-
ION FLANGE/S. CENTER YOKE/8. SELF LOCKING
NUT
(1) Apply a thin and even coat of the specified grease to the
rubber packing and fit the packing on the companion
flange.
Specified grease: Repair kit grease
(2) Align the mating marks on the center propeller shaft
and center yoke, and the rear propeller shaft and
companion flange, then press fit the center bearing
with self locking nuts, tightening to the specified
torque.
7. INSTALLATION OF LOBRO JOINT ASSEMBLY OR
D.O.J. ASSEMBLY INSTALLATION BOLTS
(1) Secure the companion flange and Lobro joint assembly
or D.O.J. assembly with installation bolts.
(2) Check for grease leakage from the Lobro joint boot or
D.O.J. boot and companion flange installation parts.
3. JOURNALS/Z. JOURNAL BEARING
(1) Apply multipurpose grease to the following parts of the
universal joint kit.
Caution
Do not apply excessive grease. Otherwise, faulty
snap rings may result.
TSB Revision