Mitsubishi 1989-1993 GALANT Service Manual page 885

Snap
REAR AXLE <AWD>
(4) Secure the B.J. boot with boot bands (A) and (C) to the
drive shaft and B.J.
Caution
Ensure that the B.J. is at a zero angle with the drive
shaft to ensure the boot contains the specified
amount of air.
inner race
1180116
7. INSTALLATION OF D.O.J. INNER RACE, CAGE AND
BALL ASSEMBLY
(1) Apply the specified grease to the D.O.J. cage, the balls
and the D.O.J. inner race.
Specified grease: Repair kit grease (As required)
(2) Install the cage, balls and inner race to the drive shaft,
then, using snap ring pliers, fit the snap ring securely
into the groove in the shaft.
5. APPLICATION OF GREASE TO D.O.J. OUTER RACE
(1) Fill the specified grease to the D.O.J. outer race, fit the
drive shaft into the D.O.J. outer race, and then fill more
grease to the D.O.J. outer race.
Specified grease: Repair kit grease
Caution
The grease in the repair kit should be divided in half
for use, respectively, at the joint
boot.
A special type of grease is used on the joint. Be
cautious to ensure that no other grease is allowed
to come in contact with the joint.
(2) Install the circlip to the D.O.J. outer race.
(3) Assemble the D.O.J. boot to the D.O.J. outer race, then
secure the boot to the drive shaft with boot band (C).
(4) Place boot band (B) on the D.O.J. boot.
NOTE
Do not secure boot band (B).
(5) Set the D.O.J. boot bands at the specified distance in
order to adjust the amount of air inside the D.O.J. boot,
and then tighten the D.O.J. boot band (C) securely.
Standard value: 76f3 mm
(6) Release a part of the D.O.J. boot from the D.O.J. outer
race to allow pressure to escape from the boot.
(7) Tighten
boot band (B) and secure the D.O.J. boot.
27-25
90 g (3.2 OZ.)
and inside the