Front Suspension Service Adjustment Procedures; Front Wheel Alignment - Mitsubishi 1989-1993 GALANT Service Manual

FRONT SUSPENSION - Service Adiustment Procedures
I
,
- a , -
TSB Revision
SERVICE ADJUSTMENT PROCEDURES

FRONT WHEEL ALIGNMENT

NOTE
The front suspension assembly must be free of worn, loose or
damaged parts prior to measurement of front wheel align-
ments.
Measure wheel alignment by using the tool.
CAMBER AND CASTER
Standard value:
Camber 22' f 30'
Caster
Camber and caster are pre-set at the factory and cannot be
adjusted.
NOTE
If camber and caster are not within specifications, replace bent
or damaged parts.
TOE-IN
Standard value: Ok3 mm (Of .12 in.)
and right tie rod turnbuckles by the same amount (in
opposite directions).
2. The toe will move out as the left turnbuckle is turned
toward the front of the vehicle and the right turnbuckle is
turned toward the rear of the vehicle.
3. For each half turn of the left and right tie rods, the toe-in will
be adjusted by 6 mm (24 in.).
4. After making the adjustments, use a turning radius gauge to
confirm that the steering wheel turning angle is within the
standard value range. (Refer to GROUP 37A-Service
Adjustment Procedures.)
WHEEL BEARING ADJUSTMENT
Bearing preload is pre-set to the specified value by design and
therefore can not be adjusted.