Mitsubishi 1989-1993 GALANT Service Manual page 854

26-24
Pry bar
FRONT AXLE - Drive Shaft
(2) Remove the drive shaft and inner shaft assembly (L.H.)
from the transaxle by lightly tapping the T.J. case with a
plastic hammer, etc.
(3) Remove the drive shaft (R.H.) as described below.
drive shaft, and then pry the drive shaft from the
transaxle.
Caution
1. Do not pull out the drive shaft; doing so will
damage the T.J.; be sure to use the pry bar.
2. Do not insert the pry bar so deep as to damage
the oil seal.
drive shaft (R.H.) from the transaxle.
Caution
Do not pull out the drive shaft; doing so will
damage the T.J.; be sure to use the pry bar.
INSPECTION
Check the drive shaft boot for damage or deterioration.
l
Check the ball joints for wear or operating condition.
l
Check the spline part for wear or damage.
l
Check the operation of the center bearing.
l
TSB Revision