Fuel Pump Replacement (Dohc); Connection Of Vapor Hose/Fillter Hose (Dohc); Connection Of High Pressure Hose To Fuel Pump (Dohc) - Mitsubishi 1989-1993 GALANT Service Manual

FUEL SYSTEM <DOHC> - Fuel Tank
hose
mm
in.)
Filler
hose
Secure side
TSB Revision
9. VAPOR HOSE/8. FILLER
CONNECTION OF
tank, and approximately 40 mm (1.6 in.) at the fuel tank
filler tube.
(2) The end of the filler hose with the shorter straight pipe
part should be connected at the tank side.
7. CONNECTION OF HIGH
PUMP
Temporarily tighten the flare nut by hand, and then tighten
it to the specified torque, bein,g careful that the fuel hose
does not become twisted.
Caution
When tightening flare nut, be careful not to bend or
twist
line to prevent damage to fuel pump low connec-
tion.
FUEL PUMP REPLACEMENT
(1) Disconnect the fuel pump connector.
(2) Remove the fuel tank filler tube cap.
(3) Drain the fuel.
high pressure hose and main pipe.
(4) Disconnect the fuel
Caution
Cover the hose connection with rags to prevent splash
of fuel that could be caused by some residual pressure
in the fuel pipe line.
(5) Loosen the self-locking nuts to the end of the stud bolt.
(6) Disconnect the lateral rod right side body coupling; then
lower the lateral rod and use wire or similar material to
suspend from the axle beam.
(7) For models equipped with the ACTIVE-Electronic Control
Suspension (E.C.S.) disconnect the rear height sensor and
the lateral rod. (Refer to GROUP 33B-Service Adjustment
Procedures.)
HOSE
PRESSURE HOSE TO FUEL