Mitsubishi 1989-1993 GALANT Service Manual page 541

AUTO-CRUISE CONTROL SYSTEM
Accelerator cable B
Intake manifold plenum
Adjusting bolts
T h r o t t l e -.--
Stopper
position swrtch
Accelerator
cable A
I
loosening the adjustment bolts at the intake manifold
plenum side and freeing the inner cable, use the adjust-
ment bolts to secure the plate so that the free play of
the inner cable becomes the standard value.
Standard value: l-2 mm (.04-.08 in.)
NOTE
If there is excessive play of the accelerator cable, the
vehicle speed drop ("undershoot") when climbing a
slope will be large.
If there is no play (excessive tension) of the accelerator
cable, the idling speed will increase.
tle position switch.
loosening the lock nut.
< M / T >
< A / T >
Caution
Do not decrease the play of cable B.
above, check to be sure that the throttle lever at the
engine side is caused to move the distance shown in
the illustration when the actuator link is turned.
(8) After adjusting, confirm that throttle valve fully opens and
closes by operating pedal.
TSB Revision
O - l m m (O-.04 in.)
2 - 3 m m (.08-.12 in.)