ENGINE <SOHC> - Oil Pan and Oil Screen
SERVICE POINTS OF INSTALLATION
2. INSTALLATION OF OIL PAN
(2) Gasket surfaces must be free of oil and dirt.
(3)
1 EN227
(4) The sealant should be applied in a continuous bead
TSB Revision
surfaces of the cylinder block and oil pan so that all
loose material is removed.
the specified sealant around the surface of oil pan
as specified in illustration.
S p e c i f i e d s e a l a n t : M I T S U B I S H I G E N U I N E P A R T
NOTE
To squeeze out proper amount of sealant, cut off the
nozzle of sealant. This will provide a nozzle 4 mm 1.16
in.) in drameter.
approximately 4 mm (.I6 in.) in diameter.