Mitsubishi 1989-1993 GALANT Service Manual page 813

AUTOMATIC TRANSAXLE
Hub
SERVICE POINTS OF REMOVAL
15. REMOVAL OF DRIVE SHAFT (R.H.)
from the front hub.
drive shaft (R.H.) from the transaxle.
Caution
Do not pull out the drive shaft; doing so will
damage the T.J.; be sure to use the pry bar.
16. DISCONNECTION OF DRIVE SHAFT (L.H.)
(1) Disconnect the inner shaft assembly from the transaxle
by lightly tapping the T.J. case with a plastic hammer,
etc.
(2) Suspend the drive shaft with wire or something similar
so that there are no sudden bends in the joints.
SERVICE POINTS OF INSTALLATION
24. INSTALLAnON OF TRANSAXLE ASSEMBLY
First install the torque converter on the transaxle and then
install the transaxle assembly on the engine.
Caution
Be sure to install the torque converter on the transaxle
first. lf it is first installed on the engine, the oil seal on
the transaxle side will be damaged.
15. INSTALLATION OF DRIVE SHAFT (R-H.)
Install the drive shaft nut for the drive shaft (R.H.) in the
following way.
specified direction.
(2) After installing the wheel, lower the vehicle to the
ground and finally tighten the drive shaft nut.
tighten the nut up to 260 Nm (188 ft.lbs.1 in maximum.
(4) Install the cotter pin in the first matching holes and
bend it securely.