Mitsubishi 1989-1993 GALANT Service Manual page 128

mark
Front of engine+
Intake side
Exhaust side
ENGINE <DOHC> - Cylinder Head Gasket
SERVICE POINTS OF INSTALLATION
57. INSTALLATION OF CYLINDER HEAD GASKET
(2) Make sure that the gasket has the proper identification
(3) Lay the cylinder head gasket on the cylinder block with
56. INSTALLATION OF CYLINDER HEAD ASSEMBLY
<Up to 1992 models>
(1) Use a scraper to clean the gasket surface of the cylin-
(2) Using the special tool and a torque wrench, tighten the
cylinder block.
Caution
Take care that no foreign material gets into the
cylinder, or into coolant passages or oil passages.
mark for the engine.
the identification mark at the front top.
der head assembly.
Caution
Take care that no foreign material gets into the
coolant passages or oil passages.
bolts to the specified torque in the order shown in the
figure. (in two or three cycles.)
Caution
Install the head bolt
diagram.
washers as shown in the