Mitsubishi 1989-1993 GALANT Service Manual page 859

Inner shaft
Inner shaft
assembly
case
T.J.
FRONT AXLE - Drive Shaft
6. INSTALLATION OF INNER SHAFT
Use the pipe to hold the inner race of the center bearing
and force the inner shaft into place.
3. INSTALLATION OF T.J. CASE AND INNER SHAFT
ASSEMBLY
(1) Apply multipurpose grease to the inner shaft spline,
(2) Using the special tools, press the seal plate into the T.J.
Seal plate
or
(3) Fill the specified grease furnished in the repair kit to the
T.J. case.
Specified grease: Repair kit grease 110 g (3.9 oz.)
The grease in the repair kit should be divided in half for
Caution
The drive shaft joint uses special grease. Do not mix
old and new or different types of grease.
2. INSTALLATlON
BOOT BAND
Set the T.J. boot bands at the specified distance in order to
adjust the amount of air inside the T.J. boot, and then
tighten the T.J. boot band securely.
Standard value: 85+3 mm (3.35-1- .12 in.)
TSB Revision
then press fit it into the T.J. case.
case.
NOTE
use, respectively, at the joint and inside the boot.
OF BOOT BAND (SMALL)/ 1. T.J.
26-29