Mitsubishi 1989-1993 GALANT Service Manual page 97

0
Plug
Crankshaft
sprocket "B"
Crankshaft
ENGINE <SOHC>
(3) Measure the rod protrusion. If it is out of specification,
replace the auto tensioner.
Standard value: 12 mm (.47 in.)
(4) Using a vise with soft jaws push in the auto tensioner rod.
If the rod can be easily retracted, replace the auto
tensioner. You should feel a fair amount of resistance when
pushing the rod in.
Caution
a level position.
2. If the plug at the bottom of the auto tensioner
protrudes, surround it with a plain washer as
illustrated to prevent the plug from being in direct
contact with the vise.
SERVICE POINTS OF INSTALLATION
28. INSTALLATION OF ENGINE SUPPORT BRACKET
BOLT
Apply sealant to the bolt shown in the figure and tighten it
to the specified torque.
Specified sealant: 3M ATD Part No.8660 or equivalent
26. INSTALLATION OF CRANKSHAFT SPROCKET "B"
Install the crankshaft sprocket "B" as shown while paying
attention to its direction.
TSB Revision