Removal Of Eye Bolt; Removal Of Fuel Filter; Fuel Line And Vapor Line Inspection; Installation Of Fuel Filter - Mitsubishi 1989-1993 GALANT Service Manual

FUEL SYSTEM <SOHC-8 VALVE> - Fuel Line and Vapor Line
High-pressur
Gasket
hose
Fuel filter
Flare nut
Fuel main
SERVICE POINTS OF REMOVAL

1. REMOVAL OF EYE BOLT

Remove the eye bolt while holding the fuel filter nut
securely.
Caution
Cover the hose connection with rags to prevent splash
of fuel that could be caused by some residual pressure
in the fuel

3. REMOVAL OF FUEL FILTER

(1) Loosen the main pipe flare nut while holding the fuel
bolts
filter nut securely.
(2) Remove the fuel filter mounting bolts, and then remove
the fuel filter from the bracket.
INSPECTION
Check the hose and pipes for cracks, bend, deformation
l
and clogging.
Check the evaporative emission canister for clogging.
l
Check the fuel filter for clogging and damage.
l
SERVICE POINTS OF INSTALLATION
6. INSTALLATION OF FUEL VAPOR HOSE/4. FUEL RE-
TURN HOSE
(1) If the fuel pipe has a stepped part, connect the fuel
hose to the pipe securely, up to the stepped part, as
shown in the figure.
(2) If the fuel pipe does not have a stepped part, connect
the fuel hose to the pipe securely, so that it is the
standard value.
Standard value: 20-25 mm (.8-1.0 in.)

3. INSTALLATION OF FUEL FILTER

(1) When installing the fuel filter, first temporarily install the
filter to the filter bracket; then insert the main pipe at
the connector part of the filter, and manually screw in
the main pipe's flare nut.
(2) Holding the fuel filter nut, tighten the fuel main pipe's
flare nut and eye bolt at the specified torque. Then
tighten the filter to the bracket.
TSB Revision
pipe line.