Mitsubishi 1989-1993 GALANT Service Manual page 791

AUTOMATIC TRANSAXLE - Service Adjustment Procedures
Switch body
TSB Revision
6. Loosen adjusting nuts A and B and keep them apart from
the adjuster, and then gently pull the end of the cable in
the direction of F.
7. Gently tighten adjusting nut A until there is contact with
the adjuster.
8. Secure adjusting nut A and then turn nut B to lock.
9. Check that the selector lever is at the "N" position.
10. Check that the manual control lever moves to the positions
corresponding to each position of the selector lever when
the selector lever is operated.
PARK/NEUTRAL POSITION SWITCH < 1990 models>
1. Place selector lever in "N" (Neutral) position.
2. Place manual control lever in "N" (Neutral) position.
3. For adjustment, turn the park/neutral position switch body
in order to align the end [12 mm (.47 in.) wide area] of the
manual control lever to the flange [I2 mm (.47 in.) wide
area] of the park/neutral position switch body.
4. Tighten the mounting bolts of the park/neutral position
switch body to the specified torque. At this time, take care
to prevent dropping the switch body.
Specified torque: lo-12 Nm (7-9 ft.lbs.)
5. Loosen the nut shown in the figure, and lightly pull the end
of the transaxle control cable in the "F" direction by hand.
6. Tighten the nut to the specified torque.
Specified torque: lo-14 Nm (7-10 ft.lbs.)
7. Check that the selector lever is in "N" po?ition.
8. Check that it securely operates and functions on the
transaxle side in the range which corresponds to each
position of the selector lever.