Mitsubishi 1989-1993 GALANT Service Manual page 850

Lubrication points
NOTE
The grease in the repair kit should be
divided in half for use. respectively, at
the ioint and inside the boot.
FRONT AXLE
SERVICE POINTS OF DESASSEMBLY
6. REMOVAL OF T.J BOOT/g. B.J. BOOT
(2) Withdraw the T.J. and R.J. boots from the drive shaft.
INSPECTION
Check the drive shaft for damage, bending or corrosion.
l
Check the drive shaft splines for wear or damage.
l
Check for entry of water and/or foreign material into R.J.
l
Check the spider assembly for ,roller rotation, wear or
l
corrosion.
Check the groove inside T.J. case for wear of corrosion.
l
Check the boots for deterioration, damage or cracking.
l
TSB Revision
Grease: Repair kit grease
120 g (4.2 oz.) <SOHC>
130 g (4.5 oz.) <DOHC>
NOTE
The grease in the repair kit should be
divided in half for use, respectively, at
the joint and inside the boot.
Wrap vinyl tape around the spline part on the T.J. side
of the drive shaft so that the T.J. and B.J. boots are not
d a m a g e d w h e n t h e y a r e r e m o v e d .
Caution
Do not disassemble the B.J.
Distinguish between B.J. boot and T.J. boot parts.