Installation Of Boot Band - Mitsubishi 1989-1993 GALANT Service Manual

Fitting
FRONT AXLE - Drive Shaft (T.J.-R.J. Type)
(7) For the boot band (small), cut away so that the length
2. INSTALLATION OF BOOT BAND (SMALL)/l. T.J. BOOT
BAND
(1) Set the T.J. boot bands at the specified distance in
(2) Apply a light coating of the repair kit grease (used in
(3) Tighten so that the outer diamter of the boot band is
(4) Using a punch, crimp the centre part of the boot band
(5) For the boot band (small), cut away so that the length
TSB Revision
of the band width remains, and then bend it over the
crimped band fitting.
For the boot band (large), cut away so that the length
until the clip holder position remains, and then secure
by the clip.
order to adjust the amount of air inside the T.J. boot,
and then tighten the T.J. boot band securely.
Standard value: L.H.
R.H. 85+3 mm (3.35f.12 in.)
the T.J.) to the installation surface of the boot band.
the dimension indicated in the illustration, and then
bend at the fitting part.
fitting so as to securely hold the band.
Caution
Care must be taken not to cut, tear or puncture the
boot.
of the band width remains, and then bend it over the
crimped band fitting.
For the boot band (large), cut away so that the length
until the clip holder position remains, and then secure
by the clip.