Tightening Torque - Mitsubishi 1989-1993 GALANT Service Manual

Each torque value in the table is a standard value for tightening under the following conditions.
(1) Bolts, nuts and washers are all mode of steel and plated with zinc.
(2) The threads and bearing surface of bolts and nuts are all in dry condition.
The values in the table are not applicable:
(2) If plastic parts are fastened.
(3) If bolts are tightened to plastic or die-cast inserted nuts.
(4) If self-tapping screws or self-locking nuts are used.
Standard bolt and nut tightening torque
Bolt nominal
Pitch
diameter
0.8
1 .o
1.25
1.25
1.25
1.5
1.5
1.5
1.5
1.5
1.5
Flange bolt and nut tightening torque
Bolt nominal Pitch
diameter
1 .o
1.25
1.25
1.5
1.25
1.75
GENERAL
Head mark
2-3 (1.4-2.2)
4 - 6 (2.9-4.3)
9 - 1 4 (6.5-10)
19-28 (14-20)
Head mark
4 - 6 (2.9-4.3)
21-31 (15-22)
19-29 (14-21)
3 8 - 5 5 (27-40)
3 4 - 5 2 (25-38)
TSB Revision
Torque Nm (ft.lbs.1
Head mark
4-6 (2.9-4.3)
7 - 1 1 (5.1-8.0)
17-26 (12-19)
3 5 - 5 5 (25-40)
Torque Nm (ft.lbs.1
Head mark
19-28
3 6 - 5 4 (26-39)
Head mark
5 - 7 (3.6-5.1)
8 - 1 2 (5.8-8.7)
Head mark
9 - 1 4 (6.5-10)
22-33
4 5 - 6 5 (33-47)