Mitsubishi 1989-1993 GALANT Service Manual page 548

AUTO-CRUISE CONTROL SYSTEM - Service
Connection of mea-
Termi-
nal sured part
Park/neutral position
17
switch (P, N)
Stop light switch
18
power supply side
Clutch pedal position
19
switch
Ground
20
I
I
Actuator motor
ment item 1 connection
Continuity
Voltage
Voltage
NOTE
actuator will become as shown in the figure at the left if
the. actuator selector is at the fully closed position when
the resistance between terminals No. 1 and No. 2 i s
measured; for that reason, after checking the polarity of
the tester, the tester's probe should be connected so that
current flows from the No. 1 terminal to the No. 2
terminal.
2. For terminals No. 8 and 14 indicated by the "2 symbol, it is
necessary to check individual terminal voltages with the
ECU's harness connector connected and with the ignition
switch ON.
(1) The No.8 terminal is normal if the diagnostic trouble
code can be confirmed. (Refer to P.13-361.)
(2) The No. 14 terminal is normal if there is approximately
and the overdrive switch switched ON. (Refer to
P. 13-349.)
VEHICLE-SPEED SENSOR INSPECTION
Refer to GROUP 54-Meters and Gauges for checking of
vehicle speed sensor.
TSB Revision
Check conditions
Other than "P" or "N" range
At all times
Clutch pedal position switch OFF
At all times
Standard
Continuity
No continui-
,