Mitsubishi 1989-1993 GALANT Service Manual page 822

PROPELLER SHAFT - Propeller Shaft
Journal
TSB Revision
SERVICE POINTS OF DISASSEMBLY
1. REMOVAL OF SNAP RING
(1) Make mating marks on the yoke and universal joint that
is to be disassembled.
2. REMOVAL OF JOURNAL BEARING
Force out the journal bearings from the yoke with a general
service tool by the following procedures.
force out the journal bearing on the opposite side.
NOTE
If the journal bearing is hard to remove, strike the yoke
with a plastic hammer.
out the remaining bearings.
7. REMOVAL OF LOBRO JOINT ASSEMBLY OR D.O.J.
ASSEMBLY INSTALLATION BOLTS
joint assembly or D.O.J. assembly.
separate the Lobro joint or D.O.J. from the companion
flange.
8. REMOVAL OF SELF LOCKING NUT/S. CENTER YOKE/
10. COMPANION FLANGE/lZ. CENTER BEARING
ASSEMBLY
center propeller shaft, and companion flange and rear
propeller shaft, remove the self locking nuts, then
remove the center yoke and companion flange.
NOTE
Be careful not to damage or deform the dust seals on
center propeller shaft assembly and rear propeller shaft.