Drive Shaft (Fwd) Removal And Installation - Mitsubishi 1989-1993 GALANT Service Manual

REMOVAL AND INSTALLATION
Removal steps
1. Front height sensor connection
<Vehicles with ACTIVE-ECS> (Refer to
l + 2. Cotter pin
l * 4. Washer
5. Self locking nut
FRONT AXLE - Drive Shaft
17-26 Nm
12-19 ft.lbs.
SERVICE POINTS OF REMOVAL
3. REMOVAL OF DRIVE SHAFT NUT
Loosen the drive shaft nut while the vehicle is on the floor
with
6. DISCONNECTION OF LOWER ARM BALL JOINT
Using the special
from the knuckle.
Caution
1. Be sure to tie the cord of the special tool to the
2. Loosen ~the nut but do not remove it.
8. DISCONNECTION OF TIE ROD END
Using the special tool, disconnect the tie rod end from the
knuckle.
Caution
1. Be sure to tie the cord of the special tool to the
TSB Revision
6
7. Cotter pin
8. Tie rod end connection
9. Drive shaft
the brakes applied.
disconnect the lower arm ball joint
tool,
nearby part.
nearby part.
Loosen the nut but do not remove it.
24-34 Nm