Mitsubishi 1989-1993 GALANT Service Manual page 851

FRONT AXLE - Drive Shaft (T.J.-B.J. Type)
SERVICE POINTS OF REASSEMBLY
9. INSTALLATION OF B.J. BOOT/6. T.J. BOOT
(3) Secure the boot bands.
2. INSTALLATION OF BOOT BAND (SMALL) / 1. T.J.
BOOT BAND
Set the T.J. boot bands at the specified distance in order to
adjust the amount of air inside the T.J. boot, and then
tighten the T.J. boot band securely.
Standard value: 8023 mm (3.15f0.12 in.)
TSB Revision
and then install the R.J. boot and T.J. boot, in that order.
order.
Caution
Distinguish between B.J. boot and T.J. boot parts
according to the section "Parts Distinction", and be
sure to assemble them correctly.
specified grease.
Specified grease: Repair kit grease
NOTE
The grease in the repair kit should be divided in half for
use, respectively, at the joint and inside the boot.
Caution
The boot bands should be tightened with the drive
shaft at a 0" joint angle.
26-21