Mitsubishi 1989-1993 GALANT Service Manual page 853

REMOVAL AND INSTALLATION
Pm-removal and Post-installation Operation
l Removal and installation of the Under Cover
43-52 ftlbs.
Removal steps
2. Drive shaft nut (Refer to P.26-13, 14.)
3. Lower arm ball joint connection (Refer to
4. Cotter pin
5. Tie rod end connection (Refer to P.26-13.)
FRONT AXLE -
26-33 ft.lbs.
8
l *
l *
SERVICE POINTS OF REMOVAL
8. REMOVAL OF DRIVE SHAFT AND INNER SHAFT
ASSEMBLY (L.H.)/9. DRIVE SHAFT (R.H.)
(1) Use the general service tool to push out the drive shaft
and inner shaft assembly (L.H.) or the drive shaft (R.H.)
from the front hub.
Drive Shaft
24-34 Nm
17-25 ft.lbs.
6. Center bearing bracket installation bolt
7. Spacer (Vehicles without air conditioning)
8. Drive shaft and inner shaft assemblv (L.H.)
9. Drive shaft (R.H.)
I
26-23
43-52 ft.lbs.
145-188 ft.lbs.