Vehicle Washing Precaution; Scan Tool - Mitsubishi 1989-1993 GALANT Service Manual

m m (tn.1

Scan Tool

(Multi-use tester<MUT>)
ROM pack
GENERAL
Caution
1. Before connecting or disconnecting the negative
cable, be sure to turn off the ignition switch and the
lighting switch.
(If this is not done, there is the possibility of
semiconductor parts being damaged.)
2. For MFI-equipped models, after completion of the
work steps [when the battery's negative (-) termi-
nal is connected], warm up the engine and allow it
to idle for approximately five minutes under the
conditions described below, in order to stabilize
engine control conditions, and then check to be
sure that the idling is satisfactory.
Engine coolant temperature: 85-95X (185-203°F)
Lights, electric fans, accessories: OFF
Transaxle: neutral position
(A/T models: "N" or "P")
Steering wheel: neutral (center) position
VEHICLE WASHING
If high-pressure car-washing equipment or steam car-washing
equipment is used to wash the vehicle, be sure to maintain the
spray nozzle at a distance of at least 300 mm (12 in.) from any
plastic parts and all opening parts (doors, luggage compart-
ment, etc.).
SCAN TOOL
(1) To operate the scan tool, refer to the "Scan Tool Operation
Instructions".
Connection
always be made with the ignition switch in the OFF
position.
(2) Always use a ROM pack that is appropriate for the vehicle.
TSB Revision
and
disconnection of the scan tool should
1992 models
I
I