Mitsubishi 1989-1993 GALANT Service Manual page 122

Sealant
Groove
cut off
ENGINE <DOHC>
SERVICE POINTS OF REMOVAL
9. REMOVAL OF OIL PAN
(2) Tap the general service tool in between the cylinder
(3) Remove the oil pan by placing a brass bar at the corner
INSPECTION
Check the oil pan for damage and cracks. Replace if faulty.
l
Check the oil screen for clogging; damage and cracks.
l
Replace if faulty.
1
SERVICE POINTS OF INSTALLATION
9. INSTALLATION OF OIL PAN
(1) Use a wire brush or other tool to scrape clean all gasket
(2) Gasket surfaces must be free of oil and dirt.
(3) Apply the specified sealant around the surface of the oil
4 m m
(4) The sealant should be applied in a continuous bead
01 BOOS1
Oil Screen
block and the oil pan.
Caution
Do not use a screwdriver, a chisel or a similar tool
when removing the oil pan.
of the general service tool and then tapping with a
hammer.
surfaces of the cylinder block and oil pan so that all
loose material is removed.
pan as specified in illustration.
Specified sealant: MITSUBISHI GENUINE PART
NOTE
To squeeze out proper amount of sealant, cut off the
nozzle of sealant. This will provide a nozzle 4 mm (.I6
in.) in diameter.
approximately 4 mm (.I6 in.) in diameter.