Kickdown Servo Adjustment - Mitsubishi 1989-1993 GALANT Service Manual

23-86 AUTOMATIC TRANSAXLE - Service Adjustment Procedures
control lever
control lever
5 mm
Section A-A i.2 in.)
<From 1991 models>
1. Place selector lever in "N" (Neutral) position.
2. Place manual control lever in "N" (Neutral) position.
3. To adjust, rotate the switch body so that the manual control
lever 5 mm (.2 in.) hole and the switch body 5 mm (.2 in.)
hole are aligned.
4. Tighten the mounting bolts of the park/neutral position
switch body to the specified torque. At this time, take care
to prevent dropping the switch body.
Specified torque: 1 O-l 2 Nm (7-9 ftlbs.)
Manual
Switch body
175133
5. Loosen the nut shown in the figure, and lightly pull the end
of the transaxle control cable in the "F" direction by hand.
6. Tighten the nut to the specified torque.
Specified torque: lo-14 Nm (7-10 ft.lbs.1
7. Check that the selector lever is in "N" position.
8. Check that it securely operates
transaxle side in the range which corresponds to each
position of the selector lever.
1. Completely remove all dirt and other materials adhered
around the kickdown servo switch.
2. Remove the snap ring.
3. Remove the kickdown servo switch.
4. To prevent rotation of the piston, engage the pawl of the
special tool into the notch of the piston, and using the
adapter, fix the piston as shown in the left.
Caution
1. Don't press in the piston with the special tool.
2. When mounting the adapter on the transaxle case,
tighten it by hand. Don't apply much torque.
TSB Revision
and functions on the